Resource Saver is a new feature available in Docker Desktop version 4.24 and later. It significantly reduces Docker Desktop's CPU and memory utilization on the host by 2 GBs or more, by automatically stopping the Docker Desktop Linux VM when no containers are running for a period of time. The default time is set to 5 minutes, but this can be adjusted to suit your needs.
With Resource Saver mode, Docker Desktop uses minimal system resources when it's idle, thereby allowing you to save battery life on your laptop and improve your multi-tasking experience.
How to configure Resource Saver#
Resource Saver is enabled by default but can be disabled by navigating to the Resources tab, in Settings. You can also configure the idle timer as shown below.
If the values available aren't sufficient for your
needs, you can reconfigure it to any value, as long as the value is larger than 30 seconds, by
changing autoPauseTimeoutSeconds
in the Docker Desktop settings.json
file:
- Mac:
~/Library/Group Containers/group.com.docker/settings.json
- Windows:
C:\Users\[USERNAME]\AppData\Roaming\Docker\settings.json
- Linux:
~/.docker/desktop/settings.json
There's no need to restart Docker Desktop after reconfiguring.
When Docker Desktop enters Resource Saver mode: - A leaf icon displays on the Docker Desktop status bar as well as on the Docker icon in the system tray. The following image shows the Linux VM CPU and memory utilization reduced to zero when Resource Saver mode is on.
- Docker commands that don't run containers, for example listing container images or volumes, don't necessarily trigger an exit from Resource Saver mode as Docker Desktop can serve such commands without unnecessarily waking up the Linux VM.
[!NOTE]
Docker Desktop exits the Resource Saver mode automatically when it needs to. Commands that cause an exit from Resource Saver take a little longer to execute (about 3 to 10 seconds) as Docker Desktop restarts the Linux VM. It's generally faster on Mac and Linux, and slower on Windows with Hyper-V. Once the Linux VM is restarted, subsequent container runs occur immediately as usual.
Resource Saver mode versus Pause#
Resource Saver has higher precedence than the older Pause feature, meaning that while Docker Desktop is in Resource Saver mode, manually pausing Docker Desktop is not possible (nor does it make sense since Resource Saver actually stops the Docker Desktop Linux VM). In general, we recommend keeping Resource Saver enabled as opposed to disabling it and using the manual Pause feature, as it results in much better CPU and memory savings.
Resource Saver mode on Windows#
Resource Saver works a bit differently on Windows with WSL. Instead of
stopping the WSL VM, it only pauses the Docker Engine inside the
docker-desktop
WSL distro. That's because in WSL there's a single Linux VM
shared by all WSL distros, so Docker Desktop can't stop the Linux VM (i.e.,
the WSL Linux VM is not owned by Docker Desktop). As a result, Resource Saver
reduces CPU utilization on WSL, but it does not reduce Docker's memory
utilization.
To reduce memory utilization on WSL, we instead recommend that
users enable WSL's autoMemoryReclaim
feature as described in the
Docker Desktop WSL docs. Finally, since Docker Desktop does not
stop the Linux VM on WSL, exit from Resource Saver mode is immediate (there's
no exit delay).
Feedback#
To give feedback or report any bugs you may find, create an issue on the appropriate Docker Desktop GitHub repository: