If you want to completely isolate the networking stack of a container, you can use the --network none flag when starting the container. Within the container, only the loopback device is created.

The following example shows the output of ip link show in an alpine container using the none network driver.

$ docker run --rm --network none alpine:latest ip link show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

No IPv6 loopback address is configured for containers using the none driver.

$ docker run --rm --network none --name no-net-alpine alpine:latest ip addr show
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever

Next steps#